lindcase
4/15/2007 6:48:42 PM
I am looking for a cold air intake for my 92 v6. I can't seem to find one anywhere. Anyone have any suggestions? Thanks.
badmonkeynobanna
5/14/2007 6:58:08 AM
you can make your own. I did, here is what I used, aem CAI pipe, silicone sleves and a and1 filter, I used an adapter plate from pepboys and just drilled it to fit the mass air sensor one on both sides of the sensor. have fun
norcalcam93
8/24/2007 10:26:06 AM
WEAPON R! go to weaponr.com
turborally
1/24/2008 7:19:34 PM
hey i got just a cone air filter on my 92 v6 and i was wonderin where did u put the air filter cause i been thinkin of monting piping so the cone filter is in the fog light hole but im not sure how good it would be and how much more cool air i would get
bigbirdSCed
2/7/2008 10:49:41 PM
one will have to be made, AEM mkaes one for the 94-96 but only the lower protion would hook up right because of the differance in the MAF sensor from the 3vz to the 1mz. as bad as it sounds, i used 3" flexible dryer tubing and ran it into the fender, popped a filter on it and it worked just as well as the AEM one. only cost me 25 bucks and 20 of that was the filter.
weapon-r does make an SRI and it would actually be good to extend into the fender from.
