Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: Interior Guides
- Toyota Camry 4th gen How to Replace Instrument Panel Cluster Bulbs
Step by step instructions for do-it-yourself repairs
Browse all: Interior Guides
dash lightbulb replacement - 01 Camry
#2
RE: dash lightbulb replacement - 01 Camry
I have the same question. Recently part of my spedometer has gone dark. It's more annoying having a partially dark dash than a hinderance right now. The wife says I don't need to see the 80-140mph part anyway since I shouldn't be driving that fast.
#3
RE: dash lightbulb replacement - 01 Camry
I dont think it's too dificult. it would just be time consuming. I remember when i did my gauges you had to take apart the dash, then the cluster/instrument panel. If i remember right, the light bulb is in back of the cluster/instrument panel and you replace the bulb as if changing the bulb on your headlights.
#4
RE: dash lightbulb replacement - 01 Camry
I can't comment on an 01. But boogz is right about not difficult but time consuming. You need patience and no inclination to force anything. I have pulled my combination meter to change a gear selection light. You need to figure out how the plastic parts are connected and attached and in which order to take them out. For instance in my 95 the plastic piece below the radio is actually hooked at the top, so I needed to pry it out from the bottom and hinge it up to remove it. The rest was just screw removal and clips. You should get a Haynes to give you the location of hidden clips and screws. As always with air bags I would disconnect the battery first and wait for 1 minute or so for the back-up capacitor to discharge.
#5
RE: dash lightbulb replacement - 01 Camry
This is really easy, I have done a ton of them. First locate the bezel screws on the top of the bezel. The bezel is the trim around the cluster. if you have a tilt, tilt it all the way down. once the screws are out pop the bezel out and expost the cluster. There will be four 4 screws holding in the cluster. remove them. this is where finesse is required. move the cluster forward toward you and gently tilt the plexy glass toward the column.You will most likely have to pull it forward a ways. Don't worry, there should be enought slack in the wiring. I believe there are four connectors back there. There may only be three, anyway you must disconnect them. Once those are disconnected, pull toward you a bit more and slide out the left of the column. To reinstall reverse removal procedure. ALSO, remember to replace ALL of the bulbs. Now that you have disturbed the placemant and shaked the cluster about, it would really suck if you had to take it back out a day or two 2 later because you left a few old ones in there. Have fun...... The toyota guy...... amdsgd
#7
RE: dash lightbulb replacement - 01 Camry
Thanks for all the help and suggestions guys. I haven't had time to fool with it so far. One of the questions I didn't ask is if it would be a good idea to change out all the bulbs...apparently my instincts were right. I think all the hidden clips and screws were making it less obvious to me, unlike my old chevy.
#8
RE: dash lightbulb replacement - 01 Camry
I haven't taken the time to attempt the bulb replacement yet........ I am a bit reluctant to risk snapping clips off without the manual. I am best off getting a manual first. I will post when I do swap the bulbs out. Tim
Thread
Thread Starter
Forum
Replies
Last Post
stockmover
PRIVATE For Sale / Trade Classifieds
1
11-20-2006 12:04 AM