1993 Timing belt install problems

	Camry Forums Classifieds Photo Gallery Member List Search Sponsors
Camry News Forum FAQ Contact Recalls TSBs Timeslips Register Login

1993 Timing belt install problems

Printable Version

Camry Forum >> Your Ride >> Engine & Internal >> 1993 Timing belt install problems

Page: [1]

Message

<< Older Topic Newer Topic >>

1993 Timing belt install problems - 12/22/2006 5:22:26 PM

madbrad

Posts: 2
Joined: 12/22/2006
Status: offline

Im all most done with changing my timing belt, but i wanted to start it before i put everything back on. Now it starts and runs good for about 5 seconds then dies. Is this timing related? When i was removing the balance i did what the manuel said and tried to pry it off and ended up chipping the balance where i think the mark for TDC was. So i have done my best to find it using a tool that is similar to a piston stop, but has a spring in it that raises and you can see it moving up when i rotate the crank. So what should i check?

Post #: 1

RE: 1993 Timing belt install problems - 12/23/2006 1:31:18 PM

lavalleemike

Posts: 427
Joined: 5/2/2006
Status: offline

It wont stay running is what your saying? Did you remove any other parts. I'd assume if it runs correctly for 5 sec. the timing should be ok...

(in reply to madbrad)

Post #: 2

RE: 1993 Timing belt install problems - 1/1/2007 3:11:25 PM

madbrad

Posts: 2
Joined: 12/22/2006
Status: offline

It dosent make it for 5 sec, probably closer to 3. Only parts i removed were the part needed to get to the timing belt.

(in reply to lavalleemike)

Post #: 3

RE: 1993 Timing belt install problems - 1/12/2007 2:57:22 AM

Joel_CA

Posts: 58
Joined: 7/9/2006
Status: offline

There's a timing mark on the crank gear behind the harmonic balancer that you can use to line it up at 1TDC. If you disconnected the battery, the ecu may have to go through an idle relearn. It can idle real low and want to die until it relearns. Driving the vehicle a few minutes will allow for relearn. Can you keep it running with the throttle?

J

(in reply to madbrad)

Post #: 4