Replaced head. Car ran fine (aside from losing coolant haha) before. I am seeing rpm on scan tool when attempting to start.
Not getting spark. Do I have this wrong?

Going to try to upload pictures of my timing.

 

Here are the cams. Crank at tdc as long as cylinder #1 is the one closest to timing chain and furthest from transmission.

 

I had intake cam notch incorrect. There were 2 notches. Car bow starts then immediately stalls. Misfire codes in all 4 cylinders.

 

What codes?

Recheck sensor connections, vacuum hoses, etc.

Did you install the timing chain per manual instructions including tensioner?

 

P0300, p0301, p0302, p0303, p0304

The first time I didn't install correctly haha. Now after 3 manual turns with tensioner on I remain timed.

Now just need to figure out what else I've done incorrectly.

 

Does the engine still have not spark?

See private message.

 

I now have spark. Engine will start then immediately stall. I believe I am missing a vacuum connection at the bottom of the intake. Looks like a square check valve or reservoir. Going to find a diagram and check my lines.

 

Post photo.