2.5 Inch Piping/ Headers&YPipe Needed *Pix Inside*
#1
08-09-2006, 10:08 PM
2.5 Inch Piping/ Headers&YPipe Needed *Pix Inside*
Here they are: Taken by my Camera phone
2.5 Inch piping connected to the Borla
Here is a shot of the piping done.
The big whole is where a cat used to be...replaced with more piping
And here is where the problem is:
Alright the problem is that, the exhaust people don't want to mess with the Y-pipe b/c it goes into a 180 first of all. And that one side of the Y comes from a cat which has a smaller pipe going into the cat itself. He said it would be hard to get to it and weld anything in there. I wanted him to just route it straight down towards the back of the car. So now i'm pretty stuck at this piont. The work that has to be done is hard too b/c the flex pipe that is there doesn't give room unless it's removed or moved down the piping. He said he could do it but it would have to go in a 180. He recommended to just buy a header and a fabricated Y-pipe. The JP Header/Ypipe pieces go for $1600. Too Expensive!!!!! So now...Any ideas?
2.5 Inch piping connected to the Borla
Here is a shot of the piping done.
The big whole is where a cat used to be...replaced with more piping
And here is where the problem is:
Alright the problem is that, the exhaust people don't want to mess with the Y-pipe b/c it goes into a 180 first of all. And that one side of the Y comes from a cat which has a smaller pipe going into the cat itself. He said it would be hard to get to it and weld anything in there. I wanted him to just route it straight down towards the back of the car. So now i'm pretty stuck at this piont. The work that has to be done is hard too b/c the flex pipe that is there doesn't give room unless it's removed or moved down the piping. He said he could do it but it would have to go in a 180. He recommended to just buy a header and a fabricated Y-pipe. The JP Header/Ypipe pieces go for $1600. Too Expensive!!!!! So now...Any ideas?
#2
10-27-2006, 10:02 PM
RE: 2.5 Inch Piping/ Headers&YPipe Needed *Pix Inside*
I would recommend JP performance I had there header on my corolla and no problems. But ya JP will negotiate prices sometimes i would just give them a call. good luck.
Thread
Thread Starter
Forum
Replies
Last Post
vistacruiser67
Suspension, Brakes, Tires & Wheels
4
10-27-2013 10:51 AM
jpease99
Nitrous, Super Chargers, & Turbos
0
08-14-2007 09:24 PM
