Hello,
I have the jbl amp 86280-ow390 and one of the pins on the amp connector both male & female side is black/melted. Does anyone have a pinout for these connectors? Would like to know where these wires go before I replace the old amp if I can find one. Took the board out of the case and it did cook a few of the parts on the board. So if anyone could help would be greatly appreciated!

 

Does anyone know of a aftermarket amp that would work?

 

Don't have pin outs, do have a wiring diagram from which you should be able to figure them out.

Send Private Message with email address.

An aftermarket amp would require rewiring.