General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

1992 2200 runability issues

Old Jun 23, 2008 | 01:17 AM
  #1  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default 1992 2200 runability issues

hi all,
i am doing my best to help my parents ,i did a search and did not find anything that mached the same problem 4-cyl automatic
some came closebuti will try andexplane , my dad mad a left turn and the car died he restarted in and it chugged and banged
and stalled coughed and sputtered and almost every time he put it in gear it would die above a out 1200 rpm it was ok , when 1 st looked at it it ran fine . i looked at it again today and it was very bad it would not idle after it was warm when it did the tach
was jumping up and down and does have a slight high rpm miss. the distributor is newer, i did not find any vacuum leaks
no codes in the computer .....any help please
 
Old Jun 23, 2008 | 05:35 AM
  #2  
pedro's Avatar
Senior Member
Joined: Jan 2007
Posts: 880
From:
Default RE: 1992 2200 runability issues

Does it run ok in gear and driving above 1200rpm or doesn't stall andidlesabove 1200rpm but won't run in gear?

If the EGR is stuck/sticking open that is the same as a vacuum leak and the car will not idle but will run at higher rpm. Removing the EGR and cleaning, as well as the exhaust tube to it, will correct.Chack the vacuum switching valve (VSV) to the EGR as well. What type of service has this car seen? When - plugs, wires, Distr, rotor?
 
Old Jun 23, 2008 | 08:11 AM
  #3  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default RE: 1992 2200 runability issues

it has 217,000 miles on it , been very well maintained cap was new with dist. plugs and wires ok.
it drives ok at 1500 to 2000 and up slight miss though the car does not idle well it starts off
pretty normal and then misses a bit the idle comes up a bit and the falls and stumbles ,
you most of the time you can not put the car in to gear when its at idle . i pulled all
spark plugs all dry , cleaned the filter on the egr (controler? located just to the right of
the egr valve) . the problem just started in the blink of an eye the car had been running
100% fine and then ?
 
Old Jun 23, 2008 | 01:38 PM
  #4  
pedro's Avatar
Senior Member
Joined: Jan 2007
Posts: 880
From:
Default RE: 1992 2200 runability issues

Try cleaning the EGR, not just the air filter on it. Also try cleaning idle air control (IAC).
These are two easy DIYr cheap trys. Does this car have a throttle position sensor?

"the problem just started in the blink of an eye the car had been running
100% fine and then ?"

I don't think that's a clue.
 
Old Jun 23, 2008 | 03:02 PM
  #5  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default RE: 1992 2200 runability issues

tps...yes...and seems to be working (viewed with scan tool)
 
Old Jun 23, 2008 | 10:17 PM
  #6  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default RE: 1992 2200 runability issues

replaced fuel filter , spark plugs , cleaned egr and iac,
now have a slight miss at idle and under quick acceleration
it stumbles
 
Old Jun 24, 2008 | 01:45 AM
  #7  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default RE: 1992 2200 runability issues

9 times i have typed all the details i could and hit the preview
and i get "Internet Explorer cannot display the webpage"
sorry for the lack of details ...still need help
well i can no longer post with out the page erroring out
so if some one give me a e-mail address i will send you the details and ]maybe you can get them to post
 
Old Jun 24, 2008 | 01:24 PM
  #8  
trkmec's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 6
Default RE: 1992 2200 runability issues

sorry frustrating as long as it took me to type all the details 6 times and have the
page error put this time
i am doning in notepad 1st .
ok i spent the afternoon working on moms car, i replaced the fuel filter and the spark plugs
i cleaned the e.g.r and the i.a.c it helped the car now idles but has a slight miss
but you can now put the car in gear and it is sort of driveable slow acceleration you can
tell it has a miss but its mild if you stomp on the accelerator the car hesitates and then
takes off like a rocket and toward upper rpm under load you can hear a whistle sound (vacuum leak?)
i dont know if the car did this before i worked on it. when you push the pedal to the floor
its almost like it boggs down and some times it will do a single small back fire and all is
ok until you slow down and step on it hard again ,
still attempting to get mom and dad back on the road
thank you for all your help so far
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
TCF Help & Suggestion Center
11
Aug 14, 2015 06:31 PM
mgray87
DIY - Do It Yourself
14
Sep 19, 2012 08:31 PM
amdsgd
Headers, Intake, & Exhaust
0
Oct 8, 2007 11:00 PM
Steve12
Engine & Internal
5
Jun 9, 2006 02:05 AM
aussiejo
Suspension, Brakes, Tires & Wheels
2
Jan 25, 2006 08:18 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 10:11 AM.