Serpentine Tensioner Pulley
#1
Serpentine Tensioner Pulley
Does anyone have a part # for just the pulley portion of the assembly? This is my wife's car which I know little about, but I knew enough to know that was the problem. I have ordered two pulleys very similar, but not the right one. I have to do all my own searching as every parts store only wants to sell me the entire assembly. Everything is fine, except the pulley. Plus that pulley is not fun to remove, and I bet the whole assembly is worse. I would appreciate any help with this. I am ready to start searching scrap yards. At least then I could get one and have new bearings pressed in.
Thanks again. J
Thanks again. J
#3
You are correct. It is the bearings. The small town I live in trying to go about getting bearings instead of the whole part is like every time I tried to explain I didn't want the entire assembly. I work 2-3 jobs, and have very little time. I will just pull the part off again. Make them match the bearings then try to press them in with a vice. I have done this before but it was SUCH a pain.
#5
you know, for the time you wasted trying to buy a right pulley, you might have driven to a good store and have that bearing matched, think ya?
#6
you know, for the time you wasted trying to buy a right pulley, you might have driven to a good store and have that bearing matched, think ya?[/quote]
Yeah, had this been my FJ62 or my Tacoma, I would have taken my time (as I can afford to have a vehicle down for a minute) this wouldn't have taken as long. Being my wife's car, everything is more rushed. She is great woman, but NOT patient. So I was trying to take what I THOUGHT was the quickest route from point A to B, take part off... put part on. Wrong. I know (very well now) how to take that pulley off. I have ordered the bearings. I will press them in or smack em with a hammer. I miss the Carquest here. Closest to my house. Knowledgeable. Was always worth the extra $ to buy from there. Sadly it is gone.
Yeah, had this been my FJ62 or my Tacoma, I would have taken my time (as I can afford to have a vehicle down for a minute) this wouldn't have taken as long. Being my wife's car, everything is more rushed. She is great woman, but NOT patient. So I was trying to take what I THOUGHT was the quickest route from point A to B, take part off... put part on. Wrong. I know (very well now) how to take that pulley off. I have ordered the bearings. I will press them in or smack em with a hammer. I miss the Carquest here. Closest to my house. Knowledgeable. Was always worth the extra $ to buy from there. Sadly it is gone.
Thread
Thread Starter
Forum
Replies
Last Post