thermostat
Member
Joined: Jan 2009
Posts: 46
From:
If your standing facing your car with the hood open,
1) look for a radiator hose. there are 2 of them. look for the one on the left side. it should lead from the bottom of your radiator to mid left side of your engine block.
2) remove the hose from the neck which is connected to the engine block.
3) remove the neck, it's held on by 2 10mm nuts.
4) remove thermostat and replace.
Clarity
how it fits (the gasket goes around the rim of the thermostat, not after it like the picture might illustrate)
=)
1) look for a radiator hose. there are 2 of them. look for the one on the left side. it should lead from the bottom of your radiator to mid left side of your engine block.
2) remove the hose from the neck which is connected to the engine block.
3) remove the neck, it's held on by 2 10mm nuts.
4) remove thermostat and replace.
Clarity
how it fits (the gasket goes around the rim of the thermostat, not after it like the picture might illustrate)
=)
Last edited by st184; Jul 10, 2009 at 02:29 AM.
Junior Member
Joined: Dec 2009
Posts: 1
Thermostat
All I can say is when I took the Manual D duct school we were told not to place the thermostat near either the sully and or return air registers as it would be possible give it a false reading. I have never put a stat near either. This is what I did.
_________________
Thermostat
_________________
Thermostat
Thread
Thread Starter
Forum
Replies
Last Post
