General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

2002 Camry problem

Old Aug 28, 2017 | 09:04 PM
  #1  
zebra50's Avatar
Thread Starter
|
Junior Member
Joined: Aug 2017
Posts: 3
Default 2002 Camry problem

Hello everybody, Newbie here. 6 months ago I bought a 2002 Camry in PERFECT condition, V6 with only 130,000 miles. It has run GREAT, but suddenly a couple day ago the blower motor quit working- No A/C or heater. I'd like to attempt to repair it myself, before putting in a shop, but I have no idea where to start! I've looked in fuse box and can't find a fuse that specifically says blower motor. Does anybody have any ideas? I would appreciate any advice. Thanks a lot!
 
Old Aug 29, 2017 | 03:58 PM
  #2  
toyomoho's Avatar
Super Moderator
Joined: Jan 2008
Posts: 15,179
From: PTW
Default

Check 50A HTR circuit breaker and 10A HTR fuse.
 
Old Aug 29, 2017 | 04:05 PM
  #3  
zebra50's Avatar
Thread Starter
|
Junior Member
Joined: Aug 2017
Posts: 3
Default

Originally Posted by toyomoho
Check 50A HTR circuit breaker and 10A HTR fuse.
OK, will try that- are they both located in the fuse box inside the car? Thanks for your reply!
 
Old Aug 29, 2017 | 04:41 PM
  #4  
toyomoho's Avatar
Super Moderator
Joined: Jan 2008
Posts: 15,179
From: PTW
Default

10A is behind drivers side dash area. Check owners manual for location.

50A is in a fuse box in engine compartment.
 
Old Sep 15, 2017 | 12:10 PM
  #5  
zebra50's Avatar
Thread Starter
|
Junior Member
Joined: Aug 2017
Posts: 3
Default

Originally Posted by toyomoho
Check 50A HTR circuit breaker and 10A HTR fuse.
Hi: I FINALLY had time to check those fuses, I found and checked the one inside the car, but I cant seem to pull the 50A, it's a square fuse (or breaker) with a clear cap, I'm afraid to tug on it too much, afraid I'll break it. How would I check it? Thanks a lot!
 
Old Sep 15, 2017 | 04:47 PM
  #6  
toyomoho's Avatar
Super Moderator
Joined: Jan 2008
Posts: 15,179
From: PTW
Default

The 50A is bolted into the box. Don't pull it out from the front.

You should be able to view the filament inside.

Or remove the HTR relay and with on, check for power at the No 5 socket pin.

Pin 1 is 12v from 10A fuse.
2 goes to AC control assy.
3 blower motor control.
4 is ground wire.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
DanielY
General Tech
4
Aug 9, 2016 09:58 AM
brzwarmwind
New Member Area
3
Feb 8, 2014 11:32 PM
Dnablood
New Member Area
14
Jan 17, 2011 09:57 PM
snation
ECU & Electronics
0
Aug 22, 2010 11:57 AM
aemravan
General Tech
1
Jul 10, 2010 03:17 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 02:50 PM.