Hi everyone,

I stumbled on this forum while looking for some information adjusting the TPS on my '99 Camry 2.2L.

First off, allow me to apologize if my questions are confusing, as I am a laymen when it comes to the terminology.

So I recently got a check engine light on my gauge cluster that read as a bad TPS sensor (which I replaced). I have searched the internet high an low, and cannot for the life of me find:

1. A diagram showing which connector pins on the TPS (3-pin) I should be testing

2. What the Volt/Ohm output I should be setting the TPS at (in other words what the normal reading I should be shooting for while the car is idling)

I am hoping that the issues Im experiencing (searching for gears, surging, lack of power, etc.) will be remedied by a correct adjustment of the TPS.

If any one of the gurus here could help me out it would be very much appreciated!! Thanks in advance for your help!