new timing belt, now won't start!
#1
new timing belt, now won't start!
My water pump drive shaft went south with the resulting slippage of the timing belt. Replaced water pump and timing belt, adjuster and idler roller, aligned all marks according to my Haynes manual, checked all vital functions and now engine will not start. Replaced coil (in distributer) and checked for spark. Checked fuel pump at filter, got fuel. Still no start. Car had been sitting for about a year cause I thought maybe valves were bent, but found out 4 cylinder engine not an interferance engine. I am ready to push car off cliff. Any suggestions? Paul
Thread
Thread Starter
Forum
Replies
Last Post
tight budget
ECU & Electronics
7
09-07-2012 05:44 PM
JCProV
ECU & Electronics
1
02-03-2012 08:19 PM
lesaroka
General Tech
1
09-12-2005 10:58 PM